Agilent / Keysight N5247B 10 MHz to 67 GHz PNA-X Microwave Network Analyzer

The Keysight N5247B PNA-X is a 10 MHz to 67 GHz microwave network analyzer engineered for R&D characterization of RF, 5G, and radar components. This integrated platform consolidates S-parameter, noise figure, and intermodulation distortion measurements into a single instrument, eliminating the need for multiple test systems. The analyzer delivers system dynamic range up to 129 dB with trace noise as low as 0.002 dB RMS, enabling high-accuracy linear and nonlinear measurements across passive and active devices.

– Technical Specifications

• Frequency Range: 10 MHz to 67 GHz
• System Dynamic Range: Up to 129 dB (129–153 dB in select configurations)
• Trace Noise: 0.002 dB RMS minimum
• Output Power: +13 dBm nominal; +10 dBm at 67 GHz
• Power Sweep Range: 40 dB
• Harmonics: −60 dBc
• Connectors: 1.85 mm coaxial; waveguide interfaces (WR12) supported for extended range
• Ports: 2-port and 4-port configurations available
• Internal Sources: Dual sources with optional third RF source (Option -XSB) up to 13.5 GHz

– Key Features

• S-Parameter Measurements: Full two-port and four-port characterization across the instrument’s frequency range
• Noise Figure Analysis: Integrated noise receiver operating to 50 GHz; Option -029 provides enhanced low-noise capabilities
• Pulsed-RF Measurements: 30 measurement points within 300 ns pulses; 10 ns timing resolution for dynamic range and power accuracy optimization
• Active Device Characterization: Optimized for amplifiers, mixers, and frequency converters with gain compression and IMD measurement capability
• Advanced Error Correction: High-accuracy linear and nonlinear device characterization through calibrated signal processing
• Configurable Test Set: Flexible RF access with bias tees and combiner integration
• IF Inputs: Option -020 provides IF input capability

– Typical Applications

• Component validation for 5G RF front-end modules
• Amplifier and converter gain, noise, and distortion characterization
• Active and passive filter measurement and optimization
• Pulsed-radar transmitter and receiver subsystem validation

– Compatibility & Integration

The instrument accepts 1.85 mm coaxial and waveguide connectors, supporting both laboratory benchtop and automated test environments through configurable port and source architectures.