Agilent / Keysight U2000A 10 MHz – 18 GHz USB Power Sensor

The Agilent/Keysight U2000A is a USB power sensor that delivers precise RF and microwave power measurements from 10 MHz to 18 GHz. Connected directly to a PC via USB 2.0, it eliminates the need for a separate benchtop power meter and streamlines test system integration. The sensor spans a dynamic range of -60 dBm to +20 dBm with dual measurement paths optimized for low and high power levels, achieving measurement uncertainty of ≤1.9% at room temperature.

– Technical Specifications

• Frequency Range: 10 MHz to 18 GHz
• Dynamic Range: -60 dBm to +20 dBm (Low Power Path: -60 to -10 dBm; High Power Path: -10 to +20 dBm)
• Measurement Speed: Up to 250 readings/second
• Measurement Uncertainty: ≤1.9% at room temperature (excluding power level dependent terms)
• Display Resolution: 1.0, 0.1, 0.01, 0.001 dB in log mode; one to four digits in linear mode
• Power Offset Range: -100 dB to +100 dB in 0.001 dB increments
• Limit Configuration: -150.00 dBm to +230.000 dBm in 0.001 dBm increments
• Connector Type: Type-N (male)
• Dimensions: 163.75 mm (L) × 46 mm (W) × 35.9 mm (H)

– Key Features

• Dual-path architecture optimizes sensitivity and dynamic range across the full power spectrum
• Internal and external triggering with burst envelope detection and graphical trace display for gate placement refinement
• Internal zeroing capability; external zeroing recommended for power levels below -30 dBm
• Selectable measurement units: Watts (W), dBm (absolute), or percentage of dB (relative)
• High and low limit thresholds with 0.001 dBm resolution
• SCPI-compatible for industry-standard system integration

– Typical Applications

• RF and microwave power validation in production test environments
• Source power calibration with PNA network analyzers
• Signal generator verification in test setups with MXG generators
• Handheld spectrum analyzer integration (N9340A/B compatibility)

– Compatibility & Integration

• Controlled by BenchVue software (version 3.0+) and the BV0007B Power Meter/Sensor Control and Analysis app at no cost
• Compatible with N1918A Power Analysis Manager software
• Integrates with Keysight MXG signal generators, N9340A/B spectrum analyzers, and PNA network analyzers
• USB 2.0 cable supplied in 1.5 m length; 3.0 m and 5.0 m options available
• Optional BNC (male) to SMB (female) trigger cable for external triggering