Agilent/Keysight PP0002A

The Keysight PP0002A is a high-voltage passive probe engineered for precision measurements on Keysight InfiniiVision and Infiniium oscilloscopes. It delivers 800 MHz bandwidth with minimal loading effects through 40 MΩ input impedance and <2 pF capacitance, making it ideal for both general-purpose and demanding high-voltage applications.

– Technical Specifications

• Bandwidth: 800 MHz
• Input Impedance: 40 MΩ || 2.0 pF
• Input Capacitance: <2 pF
• Maximum Input Voltage: 1200 Vrms (CAT II)
• Peak Transient Overvoltage: Up to 3 kV
• Rise Time (10%-90%): 500 psec
• Cable Length: 1.3 meters
• Probe Tip: Small 5 mm tip
• Series: Hi-Z+ Series

– Key Features

• AutoProbe I interface enables automatic probe identification and attenuation configuration by the oscilloscope, with offset management. Variable attenuation ratios are automatically set for large dynamic range and flat frequency response when used with the PP0004A adapter.
• High input impedance (40 MΩ) coupled with low input capacitance (<2 pF) minimizes circuit loading during measurement.
• Compact 5 mm tip design provides access to dense circuit boards and small components without sacrificing measurement stability.
• Rigid tip geometry ensures secure contact with devices under test.
• Rugged construction with replaceable probe tip cartridges extends service life and simplifies field maintenance.
• 1.3-meter cable provides convenient reach and user flexibility.

– Typical Applications

• High-voltage circuit characterization and troubleshooting up to 1200 Vrms
• General-purpose signal integrity measurements requiring minimal loading
• Transient voltage analysis with peak overvoltage capability to 3 kV
• Testing on compact PCBs where probe accessibility is constrained

– Compatibility & Integration

The PP0002A is designed for use with Keysight InfiniiVision and Infiniium oscilloscopes equipped with AutoProbe I interface support. When used with InfiniiVision X-Series and compatible Infiniium models, the PP0004A adapter (typically included) is required to enable full AutoProbe I functionality. A BNC-to-probe-tip adapter is included for additional connectivity options.