The Keysight 1147B is an active AC/DC current probe engineered for non-intrusive, high-fidelity current measurements in dynamic circuit environments. Using Hall effect sensing at DC and low frequencies, then transitioning to current transformer operation at higher frequencies, the probe delivers flat response across DC to 50 MHz with noise below 2.5 mA RMS. Its split-core clamp design enables fast connection without circuit interruption, making it ideal for transient analysis in switching supplies, motor controllers, and inverter circuits. The 1147B operates at voltage ratings to 300 V and supports peak currents to 30 A (non-continuous) or 15 A continuous/DC. Easy offset calibration and a degaussing switch minimize measurement drift and residual magnetism errors.
– Technical Specifications
• Bandwidth: DC to 50 MHz (flat frequency response)
• Current Rating: 30 A peak (non-continuous), 15 A peak (continuous), 15 A DC, 10 A continuous RMS
• Noise: <2.5 mA RMS
• Amplitude Accuracy: ±1% of reading ±10 mA
• Probe-Only Accuracy (DC or 45–66 Hz): ±1% of reading ±1 mV
• Risetime: 7 ns
• Voltage Rating: 300 V
• Cable Length: 1.5 m
• Weight: 0.47 lbs
– Key Features
• Hybrid measurement principle: Hall effect (DC–low AC) and current transformer (high-frequency) modes
• Low insertion loss for minimal circuit disruption
• Easy offset zero calibration and demagnetizing switch for rapid setup
• Protection function blocks output on excessive input
• Split-core construction for non-intrusive current insertion
– Typical Applications
• Motor controller transient analysis
• Switching power supply current profiling
• Inverter and current amplifier measurements
• Sensing, instrumentation, metering, and test & measurement
– Compatibility & Integration
The 1147B connects via Keysight AutoProbe interface and integrates directly with InfiniiVision and Infiniium oscilloscopes featuring 1 MΩ AutoProbe inputs. Recommended for 3000 X, 4000 X, 5000, 6000, and 7000 Series instruments. Use with 80000/90000 Series requires N278xA probe, N2779A supply, and E2697A adapter; 90000 X-Series requires N5449A adapter.
Reviews
There are no reviews yet.