The Keysight E7580A ProBER 2 is a handheld test set for bit error rate (BER) testing and signal quality measurements on 2 Mb/s and 64 kb/s digital circuits. It delivers comprehensive diagnostics to isolate frequency, level, pulse shape, and jitter problems on PDH signals, enabling rapid installation and maintenance troubleshooting.
Technical Specifications
Measurement Capabilities
• Bit error rate testing per ITU-T G.821 (bit, FAS, CRC, E-bit) and G.826 in-service/out-of-service modes
• Jitter measurement: 1.6 UI pk-pk (2 Hz to 100 kHz) and 15.5 UI pk-pk (2 Hz to 50 kHz) with ITU-T O.172 filters (HP1 at 20 Hz, HP2 at 18 kHz, LP at 100 kHz)
• Pulse mask characterization per ITU-T G.703 with pulse width and amplitude ratios
• Voice frequency tone generation and measurement: 300 to 3400 Hz (1 Hz steps), +3 to -40 dBm output
• Network round-trip delay: 0 to 1,999,999 µs ±1 µs accuracy
• Line rate offset display in ppm and Hz
• Signal level measurement: +4 to -28 dB relative to nominal G.703 (1 dB resolution)
• ITU-T G.704 synchronization status message decoding
Interfaces
• 2 Mb/s: HDB3/AMI on 75 ohm unbalanced (BNC) or 120 ohm balanced (3-pin Siemens)
• 64 kb/s co-directional: 120 ohm balanced (3-pin Siemens)
• Clock input: 2 MHz on 75 ohm unbalanced (BNC)
Physical & Power
• Dimensions: 270 × 133 × 54 mm; Weight: 1 kg
• Nickel metal hydride battery with >8 hours typical operating time
– Key Features
• Dual-rate operation supports 2 Mb/s primary and 64 kb/s (Option 002) secondary testing
• Integrated error and alarm generation and measurement
• M.2100 support available with Option 003
– Typical Applications
• PDH circuit validation and fault isolation on E1 and DS0 networks
• Signal quality trending for maintenance planning
• Installation verification and handover testing
– Compatibility & Integration
Designed for field use on ITU-T standardized 2 Mb/s and 64 kb/s digital interfaces with both balanced and unbalanced transmission paths.
