Agilent/Keysight MX0024A

The Agilent/Keysight MX0024A is a 20 GHz InfiniiMax Ultra Series probe amplifier engineered for high-speed digital validation and signal integrity measurements. It delivers low capacitive loading through RC input impedance architecture, preserving signal integrity while minimizing DUT impact. The amplifier supports InfiniiMode—enabling differential, single-ended A, single-ended B, and common-mode measurements from a single probe tip without reconnection.

– Technical Specifications

Bandwidth: 20 GHz
Probe Amplifier Type: InfiniiMax Ultra Series
Interface: AutoProbe 2
Total Length: 1346.2 mm (53 inches) including cable and connectors
Cable Length: 1181.1 mm (46.5 inches)

– Key Features

• Input Impedance: 25 kΩ ± 2% (single-ended); 50 kΩ ± 2% (differential) with 25 kΩ probe heads
• Dynamic Range: 600 mVpp @ 1:1; 2.5 Vpp @ 4:1; 5 Vpp @ 8:1 attenuation
• Input Common Mode Range: ± 8V (DC to 100 Hz); ± 0.5V @ 1:1 (> 100 Hz); ± 4V @ 4:1 (> 100 Hz)
• Input-Referred Noise: 16 nV/√Hz @ 1:1.56; 25.5 nV/√Hz @ 2.57:1
• Flexible Attenuation: Auto-selected 1:1, 4:1, 8:1 ratios optimize noise performance and voltage range while maintaining full bandwidth
• InfiniiMode: Single probe tip configuration for multiple signal measurement types eliminates reconnection overhead
• AutoProbe 2 Integration: Automatic probe type detection, attenuation, power, and offset configuration on compatible Keysight oscilloscopes
• Low Loading Design: RC input impedance minimizes capacitive loading across the full frequency spectrum
• S-Parameter Characterized: Enhanced measurement accuracy through frequency-domain characterization

– Typical Applications

High-speed digital design validation, differential and single-ended signal debugging, common-mode measurement, protocol analysis on bandwidth-constrained DUTs.

– Compatibility & Integration

Oscilloscope Models: Infiniium UXR-Series, 90000 X-Series, 90000 Q-Series, 90000 V-Series, Z-Series
Probe Head Support: Compatible with most InfiniiMax I and II probe heads. InfiniiMax III and III+ probe heads are not compatible with InfiniiMax Ultra series amplifiers.